0
 
You must Register and/or Login to save a shopping cart
You have 0 Items in your Cart Sub Total: $ 0.00
Providing Quality Parts to the Land Cruiser Community Since 1983
California Proposition 65 Notice
WARNING: Operating, servicing and maintaining a passenger vehicle or off-road vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, cadmium and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle. For more information go to www.P65Warnings.ca.gov/passenger-vehicle.
Monthly Specials
FJ55 Tailgate Class
Starting at: $ 155.00

Search
<<  Browse Catalog  >>


...Featured Product...

Page 324 Land Cruiser Specter's Quality Header System

<<< >>> SOR Silver Ceramic Coated Header
 

SOR Silver Ceramic Coated Headers

SOR Silver Ceramic Coated Headers
SOR Photo
#324-400 SOR
Silver Ceramic
Coated Headers

(click for large picture)


SOR recommends
purchasing Stainless
Steel Braided Oil Lines

SOR 2 Piece Silver Ceramic Coated Headers are built exclusively for Specter Off-Road in the USA.These top quality headers are designed to fit right! Made from Ceramic Coated Steel to resist corrosion.

SOR Photo
Dyno Test
(click for large picture)

We installed these headers on a 2F engine in an FJ40 without emission controls and tested the vehicle on a chassis dynamometer. The difference between the stock Toyota exhaust and the SOR Silver Ceramic Coated Headers was a maximum increase of 16.6% in horsepower and 7.9% in torque. Your engine's performance change may be different.

Header specifications: Primary tubes are 1 5/16 inch inside diameter. The primary tube average length is 33 inches. The collectors are 2 1/16 inch inside diameter. The two piece Tri-Y design eliminates header warping, allows for frame flex and the slip fit exhaust connections eliminate exhaust flange gasket leaks. Header comes with band type clamps that do not deform the pipe. These clamps make for easy removal and replacement for engine or clutch service.

Fits 1969 to 12/78 FJ40 without emission controls. Can fit 1979 to 1984 FJ40 and 1980 to 1987 FJ60 vehicles without emission controls, by modifying header pipe to fit your vehicle's exhaust system Works with column shift linkage and floorshift models. Header will not fit with PTO Winch. Comes with Kevlar header gasket.

Requires Stainless Steel Header Pipe for installation see part number #324-410.

SOR recommends purchasing Stainless Steel Braided Oil Lines. They’re longer than stock and provide better tolerance to excessive heat.

HEADERS ARE NOT LEGAL IN CALIFORNIA FOR USE ON VEHICLES EQUIPPED WITH POLLUTION CONTROLS. PLEASE CHECK YOUR LOCAL SMOG LAWS BEFORE INSTALLING HEADERS ON YOUR TOYOTA LAND CRUISER.
 
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
324-420
SOR SILVER CERAMIC COATED HEADERS -
Fits 1969-12/78 FJ40 without emission controls - Works with column shift linkage and floor shift models - Headers will not fit with PTO Winch - Can also fit 1979 to 1984 FJ40 and 1980 to 1987 FJ60 vehicles without emission controls, by modifying header pipe to fit your vehicle's exhaust system - Comes with Kevlar header gasket and two Stainless Steel Band Clamps - REQUIRES Header Pipe for installation - see part 324-410.
On Sale - Everyone gets the Discounted Price on this part.
650.00
SOR Header Pipes

SOR Header Pipes are used to adapt the SOR 2 Piece Headers to the single stock exhaust system. SOR Header Pipes are designed to run above the skid plate for better protection and ground clearance.

1969 to 1974 FJ40: SOR Header Pipe allows a bolt together connection to the factory muffler system. 1975 to 1978 FJ40: Specter recommends updating the entire muffler and tail pipe assembly to a more free flowing system. Specter offers a complete bolt on system you can install in your own driveway at a fraction of a muffler shop's price, see #324-720, #324-721, and #324-723.
Header pipe #324-410 will not fit on vehicles equipped with PTO winches, and cannot be shipped via parcel post.
 
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
324-410
SOR CERAMIC HEADER PIPE -
1969-1974 FJ40: SOR Header Pipe allows a bolt together connection to the factory muffler system. 1975 to 1978 FJ40: Specter recommends updating the entire muffler and tail pipe assembly to a more free flowing system. Specter offers a complete bolt on system you can install in your own driveway at a fraction of a muffler shop's price, see #324-720, #324-721, and #324-723. 1979 to 1987 FJ 40 and FJ60 vehicles without emission controls will need to modify this header pipe and have the rear portion of the exhaust connected by an exhaust shop.
On Sale - Everyone gets the Discounted Price on this part.
149.00
Manifold Stud Kit
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
044-02B-KIT
MANIFOLD STUD KIT -
1968-1974 F gas enginer - Kit has qty 6 manifold studs, qty 6 manifold nuts, and qty 6 manifold washers.
Club Price with 20% Discount is $ 23.92 Click here for info about joining Club SOR
29.90
044-02C-KIT
MANIFOLD STUD KIT -
1/75-8/87 2F gas engine - Kit has qty 6 manifold studs, qty 6 manifold nuts, qty 6 manifold washers, and 2 end bolts.
Club Price with 20% Discount is $ 30.40 Click here for info about joining Club SOR
38.00
Header & Manifold Gaskets
Graphite Manifold Gaskets
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
044-01B-SOR
SOR GRAPHITE MANIFOLD GASKET -
Fits 1968-1974 F gas engine. This is a compressed graphite material with a stainless steel core. This unique gasket is about 1/8 inch thick and is designed to be compressed during installation. This compression helps seal manifolds that are not perfectly flat. Resists leaks due to warping. The stainless steel core resists blowing out. The graphite material is rated for temperatures in the 2000 degree range so the material will not deteriorate due to exhaust heat. Mfg suggested fastener torque of 20-25 ft lb.
On Sale - Everyone gets the Discounted Price on this part.
29.00

SOR Kevlar Header Gaskets are specially made to be heat resistant. Long lasting to withstand temperatures up to 750 degrees Fahrenheit. Say good-bye to Asbestos header gaskets.

SOR Kevlar Header Gasket
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
324-715
15.75

Stock shaped manifold gaskets can also be used for your new SOR Silver Ceramic Coated Headers

Replacement Manifold Gaskets
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
044-01B
AFTERMARKET MANIFOLD GASKET -
Fits 1968-1974 F gas engine
On Sale - Everyone gets the Discounted Price on this part.
(an Additional Handling Charge of 1.50 is already included in price)
16.50
044-01C
MANIFOLD GASKET -
Fits 1/75-8/87 2F gas engine
On Sale - Everyone gets the Discounted Price on this part.
(an Additional Handling Charge of 1.50 is already included in price)
19.50
Exhaust Parts
Buy
Quantity
Part Number
Description
Price
In Stock
Picture
(Click to Enlarge & Close)
046-01A
4.29
046-02A
EXHAUST STUD -
Fits 1958-1967 F gas engine - Exhaust flange to manifold connection -(2 required)
On Sale - Everyone gets the Discounted Price on this part.
2.66
046-02B
EXHAUST STUD -
Fits 1968-12/74 F gas engine - Exhaust flange to manifold connection - (2 required)
Club Price with 20% Discount is $ 2.20 Click here for info about joining Club SOR
2.75
046-03A
EXHAUST STUD NUT -
Fits 1958-1967 F gas engine - Exhaust flange to manifold connection - (2 required)
On Sale - Everyone gets the Discounted Price on this part.
0.87
046-03B
EXHAUST STUD NUT -
Fits 1968-12/74 F gas engine - Exhaust flange to manifold connection - (2 required)
On Sale - Everyone gets the Discounted Price on this part.
0.87
046-04A
OEM EXHAUST PIPE FLANGE -
Fits 1958-12/74 F gas engine
(Discontinued - Not available at this time)
0.00
046-04A-A
AFTERMARKET OEM EXHAUST PIPE FLANGE -
Fits 1958-12/74 F gas engine
On Sale - Everyone gets the Discounted Price on this part.
45.00
046-04A-U
USED EXHAUST PIPE FLANGE -
Fits 1958-12/74 F gas engine
(Not available at this time-Please call for availability)
39.00
046-06B
OEM MUFFLER -
Fits 1968-1974 FJ40
Club Price with 20% Discount is $ 73.59 Click here for info about joining Club SOR
(an Additional Handling Charge of 10.00 is already included in price)
89.49
046-07B
FJ40 TAIL PIPE-
Fits 1968-12/74 FJ40-Has a 1 7/8 inch opening at muffler end
Club Price with 20% Discount is $ 62.85 Click here for info about joining Club SOR
(an Additional Handling Charge of 10.85 is already included in price)
75.85
046-08B
24.00
046-09A-A
2.67
046-09B
MUFFLER RING PAD -
Fits 1968-12/74 FJ55
On Sale - Everyone gets the Discounted Price on this part.
8.42
046-11B-A
44.00
046-12
3.14
046-13
3.61
046-23B-SS
REPLACEMENT STAINLESS STEEL BAND CLAMP -
Stainless Steel clamps - Size 57.2 MM - sold each
Club Price with 20% Discount is $ 7.99 Click here for info about joining Club SOR
9.99
Header & Manifold Installation
"...progressively tighten the fasteners..."
When installing a header or replacing a stock manifold remember to progressively tighten the fasteners keeping the mating surfaces flat against each other. For manifold studs and nuts see page 044 for other exhaust components see page 046.
<< Top of Page >>

Specter Off-Road, Inc.

World's Largest Supplier of Land Cruiser Parts & Accessories. Providing Quality Parts Since 1983
© Copyright 1996 - Specter Off-Road, Inc. All rights reserved. Specter Off-Road, Inc. is not affiliated with Toyota Motor Sales or Toyota Motor Corporation.
TT=00:00:00 419 54.156.82.247

Contact SOR
Mailing Address: 21600 Nordhoff St. Chatsworth, California 91311 USA
Customer Entrance: 21601 Osborne St. (We're a city block long)
Phone: (818) 882-1238, Fax: (818) 882-7144, Email: sor@sor.com
Hours: Monday-Friday 8:00AM-6PM PST,
Closed Saturday & Sunday