  |
Click to Browse Pages |
|
| ||
 |
Your Shopping Cart at a glance. | |
|
If you're a ClubSOR Member, be sure to log onto the Club site. Click here to log in. You will loose the items in your current shopping cart.
| ||
|
Your shopping cart is empty.
| ||
 | See page 014 for Brake Master Cylinder and 014B for Brake Booster |
 | See page 080 for front Axle Components |
 | See page 084 for 1/90 and Later Front Disc Brake Components |
 | See page 085 for 8/92 and Later Factory Rear Disc Brake Components |
 | See page 086 for Steel Brake Lines and Brake Line Kits |
 | See page 086 for Stainless Steel Braided Brake Hoses |
 | See page 090 for Factory Differentials, Diff Bearings, Gaskets & Kits |
 | See page 291 for Aftermarket Lockers, Limited Slips and Ring And Pinions |
 | See page 292 for Aftermarket Rear Disc Brake Components |
|
Page 081 — Land Cruiser Drum Brake Components
| |||||||||||||||||||||
|
| |||||||||||||||||||||
| |||||||||||||||||||||
|
| |||||||||||||||||||||
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
Specter is making ordering parts easy again with the Brake Spring Kit. By simply using one part number you can order all the brake springs and retainer clips for an entire axle. This kit includes four of each of the following part numbers: 081-16 Brake Spring, 081-17 Retainer Pin, 081-18 Retainer Clip, 081-19 Backing Plate Plugs, 018-20 Adjuster Plugs. Kit does both drums on one axle.
| |||||||||||||||||||||
|
| |||||||||||||||||||||
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
| |||||||||||||||||||||
|
Original Equipment Brake Adjusting Tool specially designed for adjusting the wheel cylinders on your Toyota Land Cruiser. This tools takes the pain out of adjusting your brakes and gets rid of those awkward screwdrivers that never really do the job right.
| |||||||||||||||||||||
|
| |||||||||||||||||||||
When rebuilding your wheel cylinders it is a good idea to rebuild both cylinders per wheel. If you rebuild only one cylinder the new rebuilt side may be stronger and tend to blow-out the weak one. Specter also recommends that all wheel cylinder adjusters should be brushed with #200-31 Anti Seize to prevent them from rusting & freezing up.
| |||||||||||||||||||||
|
|
 |
|
 |
