  |
Click to Browse Pages |
|
| ||
 |
Your Shopping Cart at a glance. | |
|
If you're a ClubSOR Member, be sure to log onto the Club site. Click here to log in. You will loose the items in your current shopping cart.
| ||
|
Your shopping cart is empty.
| ||
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
 Click an image to visit the SOR Strap Pad page and find out more
|
SOR Tuff Duck Strap & Harness Pads
|
|
| |||||||||||||||||||||||||||||
|
The early retractable Cruiser seat belts are no longer available from Toyota. Specter has located an aftermarket belt that is D.O.T. approved. This is a three point, shoulder harness type seat belt that comes with a receptacle. This Front Replacement Seat Belt fits 1/76-1/79 FJ40. The retractable belt is 115 inches long and the mechanism is located in a 4-inch x 4-inch x 3-inch plastic covered housing. The receptacle is 9 inches long and is protected by a hard plastic sleeve. The belt assembly has mounting holes for a maximum of 1/2 inch or 13mm hardware. Hardware is not included. Available in black. Sold each.
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
|
For those of you interested in putting in rear 3-point belts in your pre 8/88 60 & 62 Series wagons we have the solution. The belts from the 8/88 & later wagons cannot be used due to structural changes made to the body tub itself. SOR offers a factory O.E.M. conversion that allows you to change your existing lap belts (outer belts only) to a 3-point system with a non-retractable shoulder belt. The belt hangs down from the doorpost and clips into the retracting portion of the lap belt (included). The door post must have a threaded hole to mount shoulder belt. We highly recommend verifying that you have a threaded hole in the doorpost first (all wagons have this hole, but not all are threaded). Installation is very simple using basic hand tools. This conversion is great for those of you that have small children and would like to put their car seats in the back.
(click for large picture)
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||
|
| |||||||||||||||||||||||||||||
 |
|
 |
